Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
818
Parameter
No.
Format
Initial
value
Description Remarks
0000 Integer 0 Can’t use. (Dont change the data.)
0001 Integer 1 Sets output code of system parameter, MTF and setting data.
1: ISO 2: EIA
Only
15–TF/
15–TTF
0002 Integer 0 Sets sequence number output of NC tape
1 : Sequence number is not output.
0 : Output every process.
1 or over : Output every block (increment)
0003 Integer 1 Increment every process (If this value exceeds the increment
in a process, the initial value of the next process is set to be
larger than the final value of the previous process.)
0004 0, 1
designation (8 bits)
01100000 Can’t use. (Dont change the data.)
0005 to
0007
Character Not
defined
Can’t use. (Dont change the data.)
0008 Integer –1 Waiting time until going to the next screen after entering the
answers to all questions.
1 : No waiting time
0 : Until the soft key NEXT PAGE is pressed.
N : n second
0009 0, 1
designation (8 bits)
00010000 Specify to skip a particular question.
Bit 0 Designation of index position
Bit 1 Designation of home position
Bit 2 Designation of machining start point
Bit 3 Designation of Yaxis index and home positions
Bit 4 Selection of drawing format
Bit 6 Selection of standard surface roughness
0 : Non skip
1 : Skip
7
0
6 5
0
4 3
0
2 1 0Bit
00010 0, 1
designation (8 bits)
00011110 Skip of question on surface rughness
0 : Non skip
1 : Skipped
Bit 0 All surface roughness
Bit 1 Surface roughness to C
Bit 2 Surface roughness to G
Bit 3 Surface roughness to N
Bit 4 Surface roughness to R
7
0
6
0
5
0
4 3 2 1 0Bit
0011 Real number
1. mm specification
System variable (Do not change the setting
25.4 inch specification
by yourself.)
A.2
SYSTEM
PARAMETER TABLE

Leave a Reply

Your email address will not be published. Required fields are marked *