Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
820
Parameter
No.
RemarksDescription
Initial
value
Format
0053 0, 1
designation (8 bits)
00000000 Single step of semifinish cutting process
(Refer to parameter No.49)
0054 0, 1
designation (8 bits)
00000000 Single step of finish cutting process
(Refer to parameter No.49)
0055 0, 1
designation (8 bits)
00000000 Single step of grooving process
(Refer to parameter No.49)
0056 0, 1
designation (8 bits)
00000000 Single step of Threading process
(Refer to parameter No.49)
0057 0, 1
designation (8 bits)
00000000 Single step of cutting off process
(Refer to parameter No.49)
0100 Integer 0 0 : Absolute command NC data
1 : Incremental command NC data
0101 Integer 1 0 : Pocketing is not performed.
1 : Pocketing is performed.
2 : Lower part of overhang is machined.
0102 Integer 1 0 : Tool nose angle is not checked.
1 : Tool nose angle is checked.
0103 Integer 3 0 : Nose R is not compensated.
1 : Nose R is compensated.
2 : Nose R is compensated, and overshoot check is done.
0104 0, 1
designation (8 bits)
00000000
Bit 0 Questions of XS and ZS is
0 : Skipped
1 : Not skipped
Bit 1 Questions of firsttime override of rough cutting is
0 : Skipped
1 : Not skipped
Bit 5 At rough machining
0 : Machining is performed under an overhanging
portion.
1 : Machining is not performed under an overhanging
portion.
Bit 6 At semifinish and finish machining
0 : Machining is performed under an overhanging
portion.
1 : Machining is not performed under an overhanging
portion
Bit 7 Regarding data display
0 : 1µ or 1/10000 in unit
1 : 0.1µ or 1/100000 in unit
7 6 5 4
0
3
0
2
0
1 0Bit

Leave a Reply

Your email address will not be published. Required fields are marked *