Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
821
Parameter
No.
RemarksDescription
Initial
value
Format
0105 0, 1
designation (8 bits)
01011100
Bit 0 Constant surface speed control
0 : Not used
1 : Used
Bit 1 Coolant
0 : Not used
1 : Used
Bit 2 Cutter compensation cancel
0 : Not output
1 : Output
Bit 3 Approach
0 : Simultaneous 2 axes
1 : Simultaneous 1 axis
Bit 4 Escape
0 : Simultaneous 2 axes
1 : Simultaneous 1 axis
Bit 5 Rotating direction of spindle when cutting is made by
the turret on the front side.
Bit 6 Rotating direction of spindle when cutting is made by
the turret on the opposite side.
0 : By MTF No.1130.
1 : By MTF No.1131.
Bit 7 Setting screen for passing point
0 : Not displayed
1 : Displayed
7 6 5 4 3 2 1 0Bit
0106 0, 1
designation (8 bits)
01011100 Tapping process parameter
(Refer to parameter No.0105)
0107 0, 1
designation (8 bits)
01011100 Bar feed process parameter
(Refer to parameter No.0105)
0108 0, 1
designation (8 bits)
01011100 Center drilling process parameter
(Refer to parameter No.0105)
0109 0, 1
designation (8 bits)
01011100 Drilling process parameter
(Refer to parameter No.0105)
0110 0, 1
designation (8 bits)
01011101 Roughing process parameter
(Refer to parameter No.0105)
0111 0, 1
designation (8 bits)
01011101 Semi–finishing process parameter
(Refer to parameter No.0105)
0112 0, 1
designation (8 bits)
01011101 Finishing process parameter
(Refer to parameter No.0105)
0113 0, 1
designation (8 bits)
01011101 Grooving process parameter
(Refer to parameter No.0105)
0114 0, 1
designation (8 bits)
00011100 Threading process parameter
(Refer to parameter No.0105)
0115 0, 1
designation (8 bits)
01011101 Cutting off process parameter
(Refer to parameter No.0105)
0116 Real number
2. mm specification
Overrun in drilling a penetration hole in the
0.08 inch specification
automatic process specification
Unit: mm or inch

Leave a Reply

Your email address will not be published. Required fields are marked *