Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
822
Parameter
No.
RemarksDescription
Initial
value
Format
0117 Real number
0.5 mm specification
Finishing allowance in X axis of roughing
0.02 inch specification
Unit: mm or inch
0118 Real number
0.1 mm specification
Allowance in X axis of semi–finishing
0.04 inch specification
Unit: mm or inch
0119 Real number
0.01 mm specification
Final cutting depth of threading
0.0004 inch specification
Unit: mm or inch
0120 Real number
1. mm specification
Return relief of roughing and drilling
0.04 inch specification
Unit: mm or inch
0121 Real number 2. Cutting depth D1 (multiple of the drilling diameter) of one drilling
process (machining methods 2 and 3)
0122 Real number 5. Drawing depth D2 (multiple of the drilling diameter of drilling
(machining) method 3)
0123 Real number 0. Can’t use. (Dont change the data.)
0124 Real number
1. mm specification
Stub rate of drilling (machining method 3)
0.04 inch specification
and feed rate of return relief during necking
Unit: mm/rev or inch/rev
0125 Real number 0.6495 Inner threading
Constant to obtain threading depth from pitch
(Threading depth) = (Pitch) (Parameter No.0125)
0126 Real number 45. Threading
Boundary value of ordinary thread/face thread
0127 Real number 3. Cutting edge protection angle (degree)
0128 Real number 2000. Maximum spindle speed (rpm)
0129 Real number 1.5 Grooving dwell time (rev)
0130 Real number
0.0005 mm specification
System constant (R4TOLD) (Do not
0.0000197 inch specification
change the setting by yourself.)
0131 Real number
0.0005 mm specification
System constant (R4TOLR) (Do not
0.0000197 inch specification
change the setting by yourself.)
0132 Real number
0.01 mm specification
System constant (R4TOLT) (Do not
0.0003937 inch specification
change the setting by yourself.)
0133 Real number 0.001 System constant 4 (R4 TOLP) (Dont change this setting at
random.)

Leave a Reply

Your email address will not be published. Required fields are marked *