Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
826
Parameter
No.
RemarksDescription
Initial
value
Format
0204 Integer 1 Sets the position of parts as viewed from the advancing
direction of the definition of parts figure.
(1)
1 : Right side
1 : Left side
(when drawing format is 1 or 2)
(2)
1 : Right side
1 : Left side
(when drawing format is 3 or 4)
However, if vertical drawing display is available, right and left
should be reversed.
0205 Integer 2 Set the standard surface roughness by the number of the finish
symbols.
0206 Real number
Undefined mm specification
X–coordinate value of the machine datum
(for head 1 with the 4axis lathe). (1st
Undefined inch specification
process in doublesided machining)
Unit: mm or inch
0207 Real number
Undefined mm specification
Z–coordinate value of the machine datum
(for head 1 with the 4axis lathe). (1st
Undefined inch specification
process in doublesided machining)
Unit: mm or inch
0208 Real number
Undefined mm specification
X–coordinate value of the machine datum
Undefined inch specification
(for head 2 with the 4axis lathe).
Unit: mm or inch
0209 Real number
Undefined mm specification
Z–coordinate value of the machine datum
Undefined inch specification
(for head 2 with the 4axis lathe).
Unit: mm or inch
0210 Real number
Undefined mm specification
X–coordinate value of the turret turn
position (for head 1 with the 4axis lathe).
Undefined inch specification
(1st process in doublesided machining)
Unit: mm or inch
0211 Real number
Undefined mm specification
Z–coordinate value of the turret turn
position (for head 1 with the 4axis lathe).
Undefined inch specification
(1st process in doublesided machining)
Unit: mm or inch
0212 Real number
Undefined mm specification
X–coordinate value of the turret turn
Undefined inch specification
position (for head 2 with the 4axis lathe).
Unit: mm or inch
0213 Real number
Undefined mm specification
Z–coordinate value of the turret turn
Undefined inch specification
position (for head 2 with the 4axis lathe).
Unit: mm or inch
0213 Real number
Undefined mm specification
Z–coordinate value of the turret turn
Undefined inch specification
position (for head 2 with the 4axis lathe).
Unit: mm or inch

Leave a Reply

Your email address will not be published. Required fields are marked *