Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
831
Parameter
No.
RemarksDescription
Initial
value
Format
0369 Real number Undefined Maximum allowable rotation speed of a milling tool on tool post
2
Note) If parameter No. 369 is undefined, a value specified in
parameter No. 370 is used as the maximum allowable
rotation speed of a milling tool on tool post 2, as usual.
0370 Real number 2000. Max. rpm of tool (rpm) C–axis/
Y–axis
0371 Real number
1.0
Extension amount for approach/escape along a tangent line or
0.1
circle in Caxis milling or Yaxis contouring
0372 Real number 0.2 Cutting rate toward a diameter for Caxis face milling
For C–axis
0373 Real number
0.5 mm specification
Finishing allowance of Caxis face milling
machining
0.02 inch specification
(in the Z axis direction)
Unit: mm or inch
0400 0, 1
designation (8 bits)
00100100 Y–axis center drilling process parameter
Bit 1 Coolant
0 : Not used
1 : Used
Bit 2 Cancellation of tool compensation
0 : Not output
1 : Output
Bit 3,4 Approach
00: Simultaneous 1 axis
01: Simultaneous 2 axis
10: Simultaneous 3 axis
11: Simultaneous 4 axis
Bit 5,6 Return relief
00: Simultaneous 1 axis
01: Simultaneous 2 axis
11, 10: Simultaneous 3 axis
Bit 7 The prompt relating to the passing point is:
0 : Not displayed.
1 : Displayed.
7 6 5 4 3 2 1 0
0
Bit
For Y–axis
machining
0401 0, 1
designation (8 bits)
00100100 Y–axis drilling process parameter
(refer to the parameter No.400)
0402 0, 1
designation (8 bits)
00100100 Y–axis tapping process parameter
(refer to the parameter No.400)
0403 0, 1
designation (8 bits)
00100100 Y–axis pattern machining process parameter
(refer to the parameter No.400)
0404 0, 1
designation (8 bits)
00100100 Y–axis contouring process parameter
(refer to the parameter No.400)
0405 to
0409
0, 1
designation (8 bits)
00000000 Can’t use. (Dont change the data.) For Y–axis
machining

Leave a Reply

Your email address will not be published. Required fields are marked *