Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
835
Parameter
No.
RemarksDescription
Initial
value
Format
0702 0, 1
designation (8 bits)
00001000
Bit 0 Questioning for maximum spindle speed
0 : is not performed
1 : is performed (for each process)
Bit 1 The direction of spindle revolution for each tool
0 : can not be set (The spindle rotating direction
follows the system parameters
(No.107 to 115) per process.)
1 : can be set (Ignore the system parameter
No.107 to 115 setting.)
Bit 2 Initial value of maximum spindle speed
(Valid it bit 0 is 1)
0 : become the value of system parameter No.128
1 : become undefined data
Bit 3 In machining definition, the tool figure data:
0 : Cannot be set.
1 : can be set.
Bit 4 Special threading is:
0 : Not carried out. (A conventional triangular thread is
formed.)
1 : Carried out. (A square or trapezoidal thread is
formed.)
Bit 5 The second clearance specified for inner surface
machining is rendered:
0 : Invalid.
1 : Valid.
Bit 6 The depth of center drilling is measured from:
0 : The tool shoulder.
1 : The tool tip.
Bit 7 The method of cutting depth of drilling
0 : Cutting depth is specified by incremental
programming
1 : Cutting depth is specified by absolute programming
7 6 5 4 3 2 1 0Bit
0703 0, 1
designation (8 bits)
00000000
Bit 2 One process end, return point of turret
0 : Return to next machining start point
1 : Return to this machining start point
Bit 4 Prompting order for input of blank figure dimensions
0 : D, D0, and L
1 : L, D, and D0
Bit 5 Input of surface roughness ‘0’ is
0 : Invalid
1 : Valid
Bit 7 When the function to determine processes
automatically is used, a drill having the same diameter
as the inner surface:
0 : Cannot be used
1 : Can be used.
7 6
0
5 4 3
0
2 1
0
0
0
Bit

Leave a Reply

Your email address will not be published. Required fields are marked *