Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
836
Parameter
No.
RemarksDescription
Initial
value
Format
0704 0, 1
designation (8 bits)
00000000
Bit 0 When operating both turrets simultaneously using the
process editing function, the waiting
0 : not output before T code cancel
1 : output before T code cancel
Bit 1 At the start of new process when the spindle revolution
direction is different between new and old processes,
the spindle stop M code is
0 : not output
1 : output
Bit 2 Auto collision avoidance function is
0 : used repeatedly
1 : used once
Bit 3 For each cutting area, the T code specifying tool offset
is:
0 : Not output
1 : Output
Bit 4 Before cutting with a minor cutting edge is started for
grooving, the T code of the second tool offset number
is:
0 : Not output
1 : Output
Bit 6 Specifies whether a blank figure (BWF) is filled in on the
machining definition screen.
0 : Not filled in
1 : Filled in
(For the 5900 and 5F00 systems, a blank is not filled in
regardless of the setting of bit 6.)
Bit 7 Specifies whether a machining area (CAF) is
line–drawn.
0 : Not line–drawn
1 : Line–drawn
7 6 5
0
4 3 2 1 0Bit
TT only
0705 0, 1
designation (8 bits)
00000000
Bit 1 In the animation drawing,
0 : Upper tool is turret 1
1 : Lower tool is turret 1
Bit 5 Specifies the following when the T code cancellation
command is executed during foreground simulated
animation.
0 : The pictorial tool stops.
1 : The pictorial tool continues moving.
Bit 6 When another module requests the right to use
graphics exclusively during simulated machining,
0 : The right is not released.
1 : The right is released.
7 6
0
5 4
0
3
0
2
0
1 0
0
Bit

Leave a Reply

Your email address will not be published. Required fields are marked *