Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
837
Parameter
No.
RemarksDescription
Initial
value
Format
0706 0, 1 00000000
Next tool and rigid tapping parameter
designation
Bit 5 Calling the next tool from turret 1
0 : Not performed
1 : Performed
Bit 6 Calling the next tool from turret 2
0 : Not performed
1 : Performed
Bit 7 Format of the rigid tapping cycle
0 : A normal rigid tapping cycle is output.
1 : An interpolation rigid tapping cycle is output.
7 6 5 4
0
3
0
2
0
1
0
0
0
Bit
0707 0, 1
designation (8 bits)
00000000 Designation of balance cutting process
Bit 0 Outside diameter roughing
Bit 1 Outside diameter semi–finishing
Bit 2 Outside diameter finishing
0 : Not made to the balanced cutting process.
1 : If the condition is satisfied, it can be made to the
balanced cutting process.
Bit 5 Setting of surface speed control for balance cut B during
outer surface rough machining
0 : Constant surface speed control is not used. (G97)
1 : Constant surface speed control is used. (G96)
Bit 6 Setting of balance cut approach during outer surface
rough machining
0 : The waiting M code is not output before approach.
1 : The waiting M code is output before approach
(waiting for spindle rotation to be reached).
Bit 7 Balanced cutting type of outside diameter roughing
0 : Set the initial value of the prompt on the tool data
screen to the value of system parameter No.755 so
that type B is selected.
1 : Set the initial value of the prompt on the tool data
screen to 0 so that type A is selected.Bit
7 6 5 4
0
3
0
2 1 0Bit
TT only

Leave a Reply

Your email address will not be published. Required fields are marked *