Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
838
Parameter
No.
RemarksDescription
Initial
value
Format
0708 0, 1
designation (8 bits)
00000000
Bit 0 Common data to be restored when the power is turned
on
0 : System parameters
1 : Family data
Bit 2 Specifies whether process names are automatically
inserted for each process when an NC data is created.
0 : No process name is automatically inserted.
1 : Process names are automatically inserted.
Bit 3 Specifies whether the initial screen display function is
used.
0 : Not used
1 : Used
Bit 4 Input/output format of material data and tooling
information
0 : Binary
1 : ISO/EIA
Bit 5 Specify whether the same program is to be output for all
paths.
0 : The program number is incremented.
1 : The program number is not incremented.
Note) Specify that bit 5 of parameter No. 708 = 0 if the
workpiece turnover function is used.
Bit 7 Specify whether back machining is performed.
0 : Not performed
1 : Performed
7 6
0
5
0
4 3 2 1
0
0Bit
0709 0, 1 10000000
Can’t use. (Dont change the data.)
designation (8 bits)
Bit 4 When the cutting end point is on a blank
0 : The tool retracts to the minimum diameter of the
blank.
1 : The tool retracts in the Z axis direction.
Bit 5 Prompt for CUTTING ANOTHER AREA BY SAME
TOOL? ... CN=
0 : Displayed on the cutting condition setting screen.
1 : Displayed on the CN setting screen.
Bit 7 On the machining procedure setting screen,
0 : The machining procedure data cannot be
registered in sub–memory.
1 : The machining procedure data can be registered n
sub–memory.
0710 Integer Undefined Unused
0711 Integer 100 One time override value during outer diameter rough
machining
0712 Integer 1 Magnification of the cutting feedrate when the constant surface
speed is set for balance cut B (Setting range: 1 to 100) If the
value set for the parameter falls outside the setting range, it is
clamped to magnification 1).
0713 to
0728
Integer Undefined Can’t use. (Dont change the data.)

Leave a Reply

Your email address will not be published. Required fields are marked *