Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
66
(1)Input of equal pitch/continuous groove
This input function is used for defining a figure in which a plurality
of grooves are arranged at an equal pitch. Press ”REPEAT
GROOVE”: the display as shown below will appear.
The meaning of each question is as follows.
(a) END POINT EDX =. . . . . . . .
EZ =
Input the end point of a straight line subsequent to a continuous
groove.
When defining the groove arranged in parallel to the Zaxis, it is
not necessary to input the end point value of X.
In contrast to the above, when defining a groove arranged in
parallel to the Xaxis, it is not necessary to input the Z end point
value.
(b)QUANTITY N =. . . . . . . . .
Input the number of grooves.
(c) PITCH PT =. . . . . . . . . . . . .
Input the space from the groove entrance to the next groove
entrance.
The following question is the same as in element G.
(d)DIRECTION DN =. . . . . . . .
WIDTH WT =. . . . . . . . . . . .
DEPTH DT =. . . . . . . . . . . .
Input the groove direction, width and depth.
(e) R/C OF CORNER
K1 = V1 =
K2 = V2 =
K3 = V3 =
K4 = V4 =
Designate each corner figure.

Leave a Reply

Your email address will not be published. Required fields are marked *