Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
841
Parameter
No.
RemarksDescription
Initial
value
Format
0801 0, 1
designation (8 bits)
00000000
Bit 0 Screen display mode
0: Background color mode
1: Plain mode
Bit 1 Coloring data selection method
0: Cannot be selected on the initial screen
1: Can be selected on the initial screen
Note) If you change the screen display mode, press soft key
[SAVE END] on the setting screen and switch the power
off and on again.
7 6 5 4 3 2 1
0
0
0
Bit
0802 0, 1
designation (8 bits)
00000000
Bit 0 Specify the parameter output format for the second
spindle, as follows:
0: The parameter for the second spindle is output
using the coordinate system explained blow.
1: The parameter for the second spindle is output
using the same coordinate system as for the first
spindle.
Bit 1 Specify whether to display the CLAMP DIRECTION
prompt on the tooling information setting screen, as
follows:
0: Not to display.
1: To display.
Bit 2 Specify how to calculate the tool angular axis angle is
to be tilted in machining types other than slanted
surface machining, as follows:
0: 0 degrees
1: In accordance with the direction in which the tool is
mounted
Bit 3 Specify how to obtain the tool number, as follows:
0: Use the entered tool number without modifying it.
1: Use the lowest two digits of the entered tool number.
Bit 7 Specify how to obtain the Caxis position, as follows:
0: Use the conventional calculation method.
1: Use a calculation method that can reduce
calculation error.
7
0
6 5 4 3
0
2
0
1
0
0
0
Bit
C–axis positive
direction
C–axis
positive
direction
C–axis
positive
direction
(If bit 0 = 0)
(If bit 0 = 1)
X (C0)
Y
Y
Y
Z
Z
Z
X
(C0)
X
(C0)

Leave a Reply

Your email address will not be published. Required fields are marked *