Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
842
NOTE
The undefined character parameter is indicated with the J code. To return to undefined data
after setting data at the undefined parameter, input two or more SP codes. In this case, instead
of the J code, a space is displayed on the CRT. To change the undefined parameter to
undefined data, input
and .
DEL
INPUT
System Parameter Table Concerning Color Display
Parameter
No.
Coloring
data type
Standard
value
Details
0500 Graphic 4 Fixed picture for drawing format setting.
0501 Graphic 4 Fixed picture for blank figure and base line setting.
0502 Graphic 3 Not used.
0550 Graphic 0 Axis.
0551 Graphic 2 Lines that indicate blank figure.
0552 Graphic 1 Lines that indicate machining figure.
0553 Graphic 7 Threading area when machining is defined by menu No.4.
0554 Graphic 4 Center drilling tool path.
0555 Graphic 4 Drilling, reaming or tapping path.
0556 Graphic 2 Outside–diameter rough machining tool path.
0557 Graphic 2 Inside–diameter rough machining tool path.
0558 Graphic 2 Outside–diameter semifinish machining tool path.
0559 Graphic 2 Inside–diameter semifinish machining tool path.
0560 Graphic 6 Outside–diameter finish machining tool path.
0561 Graphic 6 Inside–diameter finish machining tool path.
0562 Graphic 5 Grooving and necking tool path.
0563 Graphic 3 Threading tool path.
0570 Graphic 2 Machining path for Yaxis machining (center drilling)
0571 Graphic 2 Machining path for Yaxis machining (drilling)
0572 Graphic 2 Machining path for Yaxis machining (tapping)
0573 Graphic 2 Machining path for Yaxis machining (patten machining)
0574 Graphic 2 Machining path for Yaxis machining (contouring)
0575 to
0578
Undefined Not used.
0579 Graphic 6 Y–axis machining parts figure
0580 Graphic 2 Machining path for Caxis machining (center drilling)
0581 Graphic 2 Machining path for Caxis machining (drill)

Leave a Reply

Your email address will not be published. Required fields are marked *