Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
846
Parameter
No.
Format
Initial
value
Description
1000 8
Characters
F16 File name (NC name)
1001 Integer 1 Z–axis command inversion
1 : Normal output
1 : Inverted output of Zaxis command value
1002 Integer 0 Reference to the NC data output format corresponding to the case when
there is no move at approach or return relief.
0 : Not referred.
1 : Referred.
1010 Real number
9999.999 mm specification
Maximum command radius of arc interpolation
999.9999 inch specification
Unit: mm or inch
1011 Real number 0.02 Can’t use. (Dont change the data.)
1020 Real number
0.001 mm specification
Z axis minimum setting unit.
0.0001 inch specification
Unit: mm or inch
1021 Real number
0.001 mm specification
X axis minimum setting unit
0.0001 inch specification
Unit: mm or inch
1022 Real number
0.001 mm specification
Y–axis minimum setting unit
0.0001 inch specification
Unit: mm or inches
1023 Real number
0.0001 mm specification
Feed per revolution and screw lead (F code)
0.000001 inch specification
Minimum setting unit: mm/rev or inch/rev
1024 Real number
0.0001 mm specification
High–precision screw lead (E code)
0.000001 inch specification
Minimum setting unit: mm/rev or inch/rev
1025 Real number 0.001 Least input increment of dwell time (sec)
1026 Real number 1.0 Can’t use. (Dont change the data.)
1028 Real number
0.001 mm specification
Least input increment for the tool angular axis angle
0.0001 inch specification
1029 Real number
0.001 mm specification
Least input increment for the angle in three
0.0001 inch specification
dimensional coordinate conversion
1030 Integer
3 mm specification
Number of decimal digits of the Z axis minimum setting
4 inch specification
unit
1031 Integer
3 mm specification
Number of decimal digits of the X axis minimum setting
4 inch specification
unit
A.3
MACHINE TOOL FILE
(MTF) TABLE

Leave a Reply

Your email address will not be published. Required fields are marked *