Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
848
Parameter
No.
Description
Initial
value
Format
1050 Integer 1 Number of turrets (1 or 2)
1 : 2spindle lathe
2 : 4spindle lathe (1 spindle/2 turrets)
1051 Integer 1 No.1 turret position
1 : Turret on this side
1 : Turret on the counter side
1052 Integer 1 No.2 turret position
1 : Turret on this side
1 : Turret on the counter side
1053 Integer –1 No.1 turret selection M code (1 is set, if not used)
1054 Integer –1 No.2 turret selection M code (1 is set, if not used)
1055 Integer 0 Setting of turret types
0 : Normal 2spindle lathe
1 : 2spindle lathe with reversible
X–axis (Chasing tool type turret, etc.)
2 : 4spindle lathe
1060 0, 1
designation (8 bits)
10000000
Bit 0 Specifies whether or not to output G50 at home position.
0 : Output
1 : Not output
Bit 1 Specifies whether or not to output the shift from home position to
index position.
0 : Output
1 : Not output
Bit 2 Specifies whether or not to output the shift from index position to
home position.
0 : Output
1 : Not output
Bit 3 Specifies whether the value is output for each axis during approach.
0 : Not output when there is no travel.
1 : Output even when there is no travel, for all axes.
Bit 6 In a threading process, the G code of multiple thread cutting cycle is:
0 : Not used.
1 : Used.
Bit 7 Specifies whether or not to use G code for fixed cycle at tapping in
turning.
0 : Not use
1 : Use
7 6 5
0
4
0
3 2 1 0Bit
1061 to
1064
Real number Undefined Can’t use. (Dont change the data.)
1070 to
1073
Real number Undefined Can’t use. (Dont change the data.)
1080 Integer 1. Program number
1 : Provided
2 : Output with main program and subprogram format.

Leave a Reply

Your email address will not be published. Required fields are marked *