Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
67
(f) SURFACE ROUGHNESS SR =. . . . .
Input the number of
marks indicating the surface roughness.
This surface roughness is applied to all elements forming this
figure. Further, it is also possible to skip this question by system
parameter No.0010 bit 2 (surface roughness to G). When skipped,
Standard Surface Roughness is adopted for the surface
roughness.
Meaning of a software key
[ESCAPE] The menu screen returns.. . . . .
[BACK PAGE] The screen, called by the sign ES = , returns. When.
this software key is pressed, the input data will
become invalid.
[CURSOR °] [CURSOR ±] The cursor goes up and down.. .
[EXEC] A shape is formed in accordance with the set data.. . . . . . .
Example)
Method of defining a figure as shown above.
a) For normal figure input:
1) Definition from the origin direction °²G²G²G²°². . .
2) Definition from the chuck direction ³±³G³G³G³±. . .
Each element is defined.
b) When the pattern figure input function is used:
1) Definition from the origin direction °². . .
2) efinition from the chuck direction ³±³. . . . .
After defining the above so far, press REPEAT & GROOVE”.
The setting of 1) above is as follows.
End point value of previous element DX = 40, Z = 8
END POINT EDX =. . . . . .
EZ = 36.0
QUANTITY N = 3. . . . . .
PITCH PT = 10.0. . . . . . . . . .
DIRECTION DN = ±. . . . .
WIDTH WT = 4.0. . . . . . . . .
DEPTH DT = 5.0. . . . . . . . . .
R/C OF CORNER
K1 = C V1 = 0.5
K2 = V2 =
K3 = V3 =
K4 = C V4 = 0.5

Leave a Reply

Your email address will not be published. Required fields are marked *