Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
851
Parameter
No.
Description
Initial
value
Format
1091 Real number
4000. mm specification
X–axis rapid feed rate (radius value)
160. inch specification
Unit: mm/min or inch/min
1092 Real number
–1. mm specification
Maximum value of highprecision screw lead (E code)
–1. inch specification
(–1.0 when no E code is specified)
Unit: mm or inch
1093 Real number
4000. mm specification
Y–axis rapid traverse rate (radius value)
160. inch specification
Unit: mm or inch
1100 Integer 4 Number of digits of sequence number (N) command
1101 Integer 0 Specification of zero suppress of F code
0 : Zero suppress is done (Leading zero are not output.)
n : F code is output in n digits at all times.
1102 Integer 4 Number of digits of S code command number
1103 Integer 4 Not used
1104 Integer 2 Number of digits of T code tool selection number
1105 Integer 2 Number of digits of T code tool offset number
1106 Integer –1 T code value to be output after all process ends (Required for returning to a
specified tool number.
This parameter is set to 1, if this function is not required.)
1107 Integer 1 Decimal point input function
0 : Not provided
1 : Provided
(If this parameter is set to 1, address P is not assignable to parameter
No.1046.)
1110 Integer –1 1st stage selection M code in spindle revolution (1, if not used)
1111 Integer –1 2nd stage selection M code in spindle revolution (1, if not used)
1112 Integer –1 3rd stage selection M code in spindle revolution (1, if not used)
1113 Integer –1 4th stage selection M code in spindle revolution (1, if not used)
1114 Real number 50 Minimum spindle speed of 1st stage (rpm) (1, if not used)
1115 Real number 5000 Maximum spindle speed of 1st stage (rpm) (1, if not used)
1116 Real number –1.0 Minimum spindle speed of 2nd stage (rpm) (1, if not used)
1117 Real number –1.0 Maximum spindle speed of 2nd stage (rpm) (1, if not used)
1118 Real number –1.0 Minimum spindle speed of 3rd stage (rpm) (1, if not used)
1119 Real number –1.0 Maximum spindle speed of 3rd stage (rpm) (1, if not used)
1120 Real number –1.0 Minimum spindle speed of 4th stage (rpm) (1, if not used)
1121 Real number –1.0 Maximum spindle speed of 4th stage (rpm) (1, if not used)
1122 Real number 0.01 Change ratio of S code output

Leave a Reply

Your email address will not be published. Required fields are marked *