Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
852
Parameter
No.
Description
Initial
value
Format
1125 Real number 0 The value set in this parameter is added to the tool angular axis angle before
output.
1130 Integer 3 M code value in normal revolution of spindle (1, if not used)
1131 Integer 4 M code value in reverse revolution of spindle (1, if not used)
1132 Integer 5 M code value in spindle stop (1, if not used)
1133 Integer 8 M code value with coolant on (1, if not used)
1134 Integer 9 M code value with coolant off (1, if not used)
1135 Integer 30 M code value in program end (1, if not used)
1136 Integer 1 Output M01 at completing a process. When “–1” is set, it is not output.
1137 Integer 98 M code for subprogram call (1, if not used)
1138 Integer 99 M code for subprogram end (1, if not used)
1139 Integer –1 Can’t use. (Dont change the data.)
1140 Integer value –1 M code for override cancel ON (for the balance cut FAPT, type B) (When not
in use: 1)
1141 Integer value –1 M code for override cancel ON (for the balance cut FAPT, type B) (When not
in use: 1)
1142 Integer –1 M code for clockwise rotation of the 2nd spindle (for back machining)
(Not used: –1)
1143 Integer –1 M code for counterclockwise rotation of the 2nd spindle (for back machining)
(Not used: –1)
1144 Integer –1 Cannot be used. (Do not change the data.)
1145 Integer –1 M code for starting back machining (Not used: –1)
1146 to
1149
Integer –1 Cannot be used. (Do not change the data.)
1201 Integer 1 Cutting feed G code
1202 Integer 2 Circular interpolation (CW) G code
1203 Integer 3 Circular interpolation (CCW) G code
1204 Integer 32 Threading G code
1205 Integer 92 Canned cycle G code
1206 Integer 90 Not used
1207 Integer 94 Not used
1210 Integer 97 Constant surface speed control off G code
1211 Integer 96 Constant surface speed control on G code
1220 Integer –1 Absolute command mode G code
1221 Integer –1 Incremental command mode G code

Leave a Reply

Your email address will not be published. Required fields are marked *