Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
854
Parameter
No.
Description
Initial
value
Format
1304 0, 1
designation (8 bits)
00000011 Drilling canned cycle in each process (C–axis/Y–axis)
0 : Not used.
1 : Used.
Center drilling
Drilling
1305 Specified with 0 or
1 (8 bits)
00000000
Bit 0 IN front notching, finishing of Yaxis pattern machining, and
contouring, cutter compensation is carried out by:
0 : FAPT (G40, G41, and G42 are not output.)
1 : NC (G40, G41, and G42 are output.)
Bit 1 Specifies whether the radius command for cylindrical interpolation is
output with a decimal point.
0 : No decimal point
1 : With a decimal point
7
0
6
0
5
0
4
0
3
0
2
0
1 0Bit
1306 Integer 0 Method of Caxis control
0 : Servo motor control method
1 : Spindle positioning method
1307 Integer 0 When controlled axes are simultaneous 2 axes.
0 : XZ axes are simultaneous 2 axes.
1 : XCaxis or ZCaxis are simultaneous 2 axes.
1308 Integer 0 Command method at the time of spindle positioning
0 : Half fixation angle indexing
1 : Arbitrary angle indexing
1309 Real number
1. mm specification
Feed rate (feed per minute)
0.01 inch specification
Minimum setting unit: mm or inch
1310 Integer
0 mm specification
Number of decimal digits of the minimum setting unit of
2 inch specification
feed rate per minute
1311 Real number 0.01 No use
1312 Integer –1 No use
1313 Integer –1 M code of forward tool rotation
1314 Integer –1 M code of reverse tool rotation
1315 Integer –1 Milling start M code
1316 Integer –1 Cutting start M code
1317 Integer –1 Orientation M code
1318 Integer –1 Spindle positioning release M code
1319 Integer –1 Spindle indexing M code
1320 Real Undefined Indexing angle
1321 to
1339
Integer –1 Can’t use. (Dont change the data.)

Leave a Reply

Your email address will not be published. Required fields are marked *