Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
856
Parameter
No.
Description
Initial
value
Format
1394 2
characters
QQ
DD
Address specifying the depth of the first cut for a multiple thread cutting cycle
(High order: 5710, low order 5E00)
1395 2
characters
PP
AA
Address specifying a tool angle for a multiple thread cutting cycle (High order:
5710, low order 5E00)
1396 2
characters
PP
PP
Address specifying the cutting method for a multiple thread cutting cycle
(High order: 5710, low order 5E00)
1397 2
characters
RR
RR
Address specifying a finishing allowance for a multiple thread cutting cycle
(High order: 5710, low order 5E00)
1398 2
characters
FF Pitch command address for the interpolation type rigid tapping cycle
1399 2
characters
TT Cut–in direction command address for the interpolation type rigid tapping
cycle
1400 2
characters
BB Command address for a nexttool call
1404 2
characters
RR Address of the rotation angle address in threedimensional coordinate
conversion
1405 2
characters
BB Address of the tool angular axis angle
1406 2
characters
HH Address of the spindle number
1407 2
characters
II Address of the turning tool clamp type
1410 3
characters
–1 M code for rotating the second spindle in the normal direction (back
machining)
1411 3
characters
–1 M code for rotating the second spindle in the reverse direction (back
machining)
1412 3
characters
5 M code for causing the second spindle to stop rotating (back machining)
1413 3
characters
–1 M code for connecting the Caxis on the second spindle (back machining)
1414 3
characters
–1 M code for disconnecting the Caxis on the second spindle (back machining)
1415 3
characters
68 M code for clamping the Caxis on the second spindle (back machining)
1416 3
characters
69 M code for unclamping the Caxis on the second spindle (back machining)
1417 3
characters
–1 Tool spindle (normal rotation) M code for tool post 2
Note) If MTF1417 = 1, the M code for tool post 2 is the same as the M code
specified for tool post 1.
1418 3
characters
–1 M code for the tool spindle (reverse rotation) on tool post 2

Leave a Reply

Your email address will not be published. Required fields are marked *