Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
857
Parameter
No.
Description
Initial
value
Format
1420 5
characters
–1 M code for tool attitude 1 (for foreground animated simulation)
1421 5
characters
–1 M code for tool attitude 2 (for foreground animated simulation)
1422 5
characters
–1 M code for tool attitude 3 (for foreground animated simulation)
1423 5
characters
–1 M code for turning tool orientation 1 (for foreground animated simulation)
1424 5
characters
–1 M code for turning tool orientation 2 (for foreground animated simulation)
CAUTION
Parameter numbers other than listed above may also
appear on the CRT. These parameters are employed the
system.
Don’t change them.

Leave a Reply

Your email address will not be published. Required fields are marked *