Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
859
Parameter No. RemarksMeaning
2021 Output of circular interpolation move command block In case of radius R command.
2022 Threading command block output Tapping process retapping command
when threading cycle is not used and
MTF 1060 bit 7 is set to 0
2023 Output of threading cycle command block In case of the threading cycle used.
2024 Output of spindle speed command block rpm command
2025 Output of spindle range changeover block The spindle range is changed over.
2026 Output of a threading command block When no threading cycle is used
2027 Output of dwell command block
2028 Constant surface speed control ON
2029 Unused.
2030 Output of spindle maximum speed clamp value command block G50S_ ;
2031 1st motion for approach in one axis at a time
2032 2nd motion for approach in one axis at a time
2033 1st motion for return relief in one axis at a time
2034 2nd motion for return relief in one axis at a time
2035 Starting part of cuttingoff processing
2036 Starting part of bar feed processing
2040 End section of cuttingoff processing Tool offset cancel, M01, etc.
2041 End section of bar feed processing Tool offset cancel, M01, etc.
2045 Output of a specific cedeFor model TT only For model TT only
2046 Simultaneous 2axis approach move command of bar feed M05;
G00X_ Z_ ; etc.
2047 Simultaneous 1axis approach 1st motion M05;
G00X_ ; etc.
2048 Simultaneous 1axis approach 2nd motion M05;
G00Z_ ; etc.
2049 Move command to the work gripping position in bar feed G98G01Z_ F_ ; or
G98G01X_ F_ ;
2050 Dwell command when the chuck of bar feed is to be opened. M_ ;
G04U_ ; etc.
2051 Move command for work feeding in bar feed. G01Z_ F_ ; etc.
2052 Dwell command when the chuck of bar feed is to be closed. M_ ;
G04U_ ;
2053 Move command 1 after work feeding in bar feed. G01Z_F_ ; or
G01X_ F_ ;
2054 Move command 2 after work feeding in bar feed G00Z_ ;

Leave a Reply

Your email address will not be published. Required fields are marked *