Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
860
Parameter No. RemarksMeaning
2055 Starting section for reaming
2056 Starting section for tapping
2057 Ending section for reaming
2058 Ending section for tapping
2059 Command block outputs for tapping cycle (G84) and reverse
tapping cycle (G84.1)
Tapping process relief cutting
command when canned cycle is used
and MTF 1060 bit 7 is set to 1
2060 Command block 1 for a multiple thread cutting cycle
2061 Command block 2 for a multiple thread cutting cycle
2065 Outputs the T code specifying tool offset for each cutting area.
Outputs the T code specifying the second tool offset for grooving
TXXXX;
2066 Block for preparing the next tool
2067 Block for cutting with balance cut B
2068 Setting of the coordinate system for turning and T code output (Back machining)
2069 Setting of the coordinate system for milling and T code output (Back machining)
2070 Beginning part of Yaxis machining (CAUTION 1)
2071 Beginning part of Yaxis center drilling
2072 Beginning part of Yaxis drilling
2073 Beginning part of Yaxis tapping
2074 Beginning of Yaxis pattern
2075 Beginning of Yaxis contouring
2080 Not used
2081 End part of Yaxis center drilling
2082 End part of Yaxis drilling
2083 End part of Yaxis tapping
2084 End of Yaxis pattern
2085 End of Yaxis contouring
2100 Start of main program
2101 End of main program
2102 Start of subprogram FEED, O_ , etc.
2103 End of subprogram M99, M30, FEED, etc.
2104 Subprogram call block M98P_ ;
2110 Beginning of a turning process (CAUTION 2)
2111 Beginning of a milling process (CAUTION 3)

Leave a Reply

Your email address will not be published. Required fields are marked *