Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
867
Most significant
3 digits (detailed
classification)
RemarksFunction
Least significant
1 digit (major
classification)
4 0 0 2 G code output (G04) set to
MTF 1240
G code output of MTF 1240 1251
4 1 0 2 G code output (G28) set to
MTF 1241
CAUTION
The G code of MTF 1240 1251 is not modal
managed. Thus, when the function code
4 2 0 2 G code output (G29) set to
MTF 1242
specifying these G code is referred to, the G code
is always output. Also, this G code is not output
when –1 is set to MTF 1240 1251.
4 3 0 2 G code output (G30) set to
MTF 1243
4 4 0 2 G code output (G50) set to
MTF 1244
4 5 0 2 G code output (G70) set to
MTF 1245
4 6 0 2 G code output (G71) set to
MTF 1246
4 7 0 2 G code output (G72) set to
MTF 1247
4 8 0 2 G code output (G73) set to
MTF 1248
4 9 0 2 G code output (G74) set to
MTF 1249
4 A 0 2 G code output (G75) set to
MTF 1250
4 B 0 2 G code output (G76) set to
MTF 1251
4 C 0 2 G code set to MTF1252 or
MTF1253 is output
G code for selecting a back machining coordinate
system
5 0 0 2 MTF 1200 (G00) or 1201
(G01) is output
The G code of MTF 1200 and 1201 are output in the
case of rapid traverse move and cutting feed (line),
respectively.
5 1 0 2 MTF 1202 (G02) or 1203
(G03) is output
The G code of MTF 1202 and 1203 are output in the
case of CW circular and CCW circular, respectively.
5 2 0 2 G codes of MTF 1220 and
1221 are output
The G codes of MTF 1220 and 1221 are output in the
case of absolute command and incremental
command, respectively.
5 3 0 2 Output MTF 1231 (G41) or
1232 (G42)
MTF 1231 for left side cutter compensation MTF 1232
for right side cutter compensation
5 5 0 2 G codes of MTF 1202 and
1203 are output
The G codes of MTF 1203 and 1202 output in the
case of CW circular and CCW circular, respectively.
5 6 0 2 G codes of MTF 1222 and
1223 are output
The G codes of MTF 1222 and 1223 are output in the
case of mm input and inch input, respectively.

Leave a Reply

Your email address will not be published. Required fields are marked *