Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
869
(d)Output of F, S, and T codes
When the least significant 1 digit (major classification) is 3 ...
***3;
Most significant
3 digits (detailed
classification)
Least significant
1 digit (major
classification)
Function Remarks
0 0 0 3 Tool offset cancel T code
output
It depends on the setting of process parameter of
system parameter whether the T code is actually
output.
0 1 0 3 T code output Tool offset start
0 2 0 3 S code (rpm) output It is output only when the change rate from the speed
output immediately before exceeded the setting
value of MTF 1122.
0 3 0 3 Maximum speed clamp
value S code output
It is output only when the MTF 1085 has the constant
surface speed control function and the constant
surface speed control function is used in the process
parameter (system parameter 0108 0114).
0 4 0 3 Surface speed command S
code output
0 5 0 3 F code output It is output only in the case of cutting feed. It is
compared with the modal value and is output only
when it is a different value.
0 6 0 3 Output of program number It is not output when 0 is set to MTF 1080.
0 7 0 3 Final T code output The T code set to the MTF 1106 is output. No output
is made when 1 has been set.
0 8 0 3 Output of subprogram call
P code
The subprogram number (PXXXX) is output by the
subprogram call program (M98PXXXX).
0 9 0 3 R code output For canned cycle
0 A 0 3 Q code output For canned cycle
0 B 0 3 L code output For canned cycle
0 C 0 3 P code output For canned cycle
0 D 0 3 Outputs the address specified in MTF 1395. Tool angle (valid for the Series 15 only)
0 E 0 3 Outputs the address specified in MTF 1395. Tool angle (valid for the Series 16 only)
0 F 0 3 Outputs the address specified in MTF 1396. Specified cut method (valid for the
Series 15 only)
1 0 0 3
F code output Interpolation rigid tapping cycle
Outputs the address
specified in MTF1398
1 1 0 3
T code output Interpolation rigid tapping cycle
Outputs the address
specified in MTF1399

Leave a Reply

Your email address will not be published. Required fields are marked *