Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
69
i) The figure defined by REPEAT GROOVE is defined as an
element by the arrow and G element row.
ii) Correct for each element. This is the same for the deletion.
iii)The relation between the pitch and groove is as shown below.
When DN = ± When DN = ²
NOTE
For pattern figure input, the end point value of the previous
element should already be fixed.
(2)Neck corner input
It is possible to define 3 types of DIN Standard neck corners. If
NECK CORNER is pressed, the display changes on the next screen.
³NECK CORNER
In response to the question TYPE =, enter the neck figure type
number (13) for the type to be set.
The meaning of soft keys
“ESCAPE” Returns to the menu screen.. . . . . . . . . .
BACK PAGE Returns to the ES = question screen.. . . . . .

Leave a Reply

Your email address will not be published. Required fields are marked *