Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
881
The following example describes where MTF parameter Nos. 2000 to
2999 are referenced by Symbolic FAPT when it prepares NC data.
(Example) Outer surface rough machining
In the process of making up the NC data which commands the machinings
of (1) to (19), the parameters 2000s are referred to as follows:
Point to be Referred to Parameter
No.
Description
(1) Home position (start of program)
2000 Feed, EOR, program No.
2016 G50X_ Z_ ;
(2) Home position
Exchange point of tool
2017 Move to the tool exchange point
G00X_ Z_ ;
(3) Tool change point (start of process)
2002 to
2008
or
2035
or
2036
In case of the beginning part of process, or rough machining of
outer diameter, 2004 is referred to.
2016 G50X_ Z_ S;
G00T_ ;
2024
or
2028
Output of spindle speed G97S_M03;
Constant surface speed ON
G97S_ M03;
A.4.4
Reference of Function
Table

Leave a Reply

Your email address will not be published. Required fields are marked *