Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
882
Point to be Referred to
Description
Parameter
No.
The first move from the tool exchange point.
Coolant ON
(4) Approach
2018
or
2031
2032
In case the machining process except for the bar feed process
2018 is referred to for 2 axes at–a–time, 2031 and 2032 are
referred to for 1 axis at–a–time. At the same time whether it is axis
2 or axis 1, it is according to the system parameter setting No.108
115 of bit 3.
2046
or
2047
2048
In case of bar feed process 2046 is referred to for 2 axes
at–a–time, 2047 and 2048 are referred to for 1 axis at–a–time.
At the same time whether it is axis 2 or axis 1, it is according to
the system parameter setting No.107 of bit 3.
(5) – (11) (13) (15)
Linear move
2017 Rapid traverse, cutting feed (linear) move command.
(5), (10)
Spindle range switch
2025
2024
When constant surface speed control is not performed:
Spindle range switch
No. of spindle revolution output
2030
2025
2028
When constant surface speed control is performed
Spindle max. speed clamp
Spindle range switch
Constant surface speed ON
According to MTF 1110 to 1121 setting
(12) Circular move 2020
2021
Circular interpolation move command. 2020 is referred to when
MTF 1082 = 0, 1 (I, K command) and 2021 is referred to when
MTF 1082 = 2, 3 (radius R command).
(16) Escape 2019
2033
2034
Move command to tool exchange point. Coolant OFF. 2019 is
referred to for 2 axes at–a–time, 2033 and 2034 are referred to
for 1 axis at–a–time. At the same time whether it is axis 2 or axis
1, it is according to the system parameter setting No.107 115 of
bit 4.
(17) Tool change point (end of process) 2009 to
2015
or
2040
or
2041
The end part of process.
In case of outer diameter rough machining, 2011 is referred to.
TXX00; M01;
(18) Tool change point
Machine datum
2017 Move to home position G00 X_ Z_ ;
(19) Home position (end of program) 2001 Trailer part Spindle stop, tool offset cancel, program stop, EOR

Leave a Reply

Your email address will not be published. Required fields are marked *