Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
887
3) Slide stop system 1
Point referenced
Parameter
No.
Descriptions
(1) Home position (start of program)
2000 Feed, EOR, and program number
2016 G50 X_ Z_ ;
(2) Home position
Tool exchange point
2017 Movement to the tool exchange point
G0 X_ Z_ ;
(3) Tool exchange point (start of process)
2036 Start part of bar feed process
2016 Coordinate system setting and tool selection
G50 X_ Z_ S_ ;
G0 T_ ;
2024
or
2028
When constant surface speed control is not performed:
G97 S_ M03 ;
When constant surface speed control is performed: G96 S M3;
It follows the setting of bit 0 of system parameter number 107.

Leave a Reply

Your email address will not be published. Required fields are marked *