Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
892
Point referenced
Parameter
No.
Descriptions
(5) (9)
In the case of MTF No.1304 bit 1 = 0 (when no drilling canned cycle is used)
Line or rotation shift
In the case of servo motor control system
2017 Rapid traverse and cutting feed (line or rotation) shift commands
In the case of spindle positioning system
2017
2211
Rapid traverse and cutting feed (line) shift commands. Spindle
identification comman
In the case of MTF No.1304 bit 1 = (the drilling canned cycle is used)
In the case of servo motor control system
2203 to
2206
Drilling canned cycle command (line or rotation shift)
In the case of spindle positioning system
2203 to
2206
2211
Drilling canned cycle command (Linear move)
Spindle identify command
(10) Escape
2019 or
2033 and
2034
Shift command to tool exchange point Coolant off
Simultaneous 2 axes
Simultaneous 1 axis
Select the Simultaneous 2 axes or 1 axis depending on the
setting of bit 5 of system parameter No.300 to 304.
(11) Tool exchange point (end of process) 2201 End part of process
TXX00 ;
M1 ;
(12) Tool exchange point
Home position
2017 Shift to the home position
G0 _ Z ;
(13) Home position (end of program) 2001 Trailer part
Spindle stop and tool offset cancel
Program stop and EOR

Leave a Reply

Your email address will not be published. Required fields are marked *