Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
894
NOTE
1 When the Caxis machining process has been continuously
defined, the second process and thereafter are not
referenced.
2 The polar coordinate interpolation is started before the point
(5) of line shift.
Point referenced
Parameter
No.
Description
(6), (8), (9), and (11)
Circular move
2020 or
2021
Circular interpolation shift command (NOTE 3)
MTF 1082 = 0, 1 (I and J commands)
MTF 1082 = 2, 3 (Radius R command)
(13) Escape
2019 or
2033 and
2034
Shift command to tool exchange point Coolant off
Simultaneous 2 axes
Simultaneous 1 axis
Select the Simultaneous 2 axes or 1 axis depending on the
setting of bit 5 of system parameter No.304.
(14) Tool exchange point (end of process) 2201 End part of process
TXX00 ;
M1 ;
(15) Tool exchange point
Home position
2017 Shift to the home position
G0 X_ Z_ ;
(16) Home position (end of program) 2001 Trailer part
Spindle stop and tool offset cancel
Program stop and EOR
NOTE
3 Cancel the polar coordinate interpolation after the point (11)
of circular shift

Leave a Reply

Your email address will not be published. Required fields are marked *