Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
896
Parameters MTF 2300 to MTF 2399 are listed in the function table
specifying special function codes. Special NC data items can be output
to any block according to the table.
(1)Function table specifying special function codes
Parameter No. Meaning Remarks
2300 Output of special
function codes
Maximum number of the codes that can
be specified: 10
2301 Same as above Same as above
2303 Same as above Same as above
2304 Same as above Same as above
2305 Same as above Same as above
2306 Same as above Same as above
2307 Same as above Same as above
2308 Same as above Same as above
2309 Same as above Same as above
(2)Function code
The following function code is added to reference the optional
function table:
(a) Referencing the optional function table
3 high–order
digits
(detailed
classification)
1 low–order
digit
(major
classification)
Function Remarks
0 0 0 E The function table specified by
the 1word hexadecimal number
listed in the following table is
referenced to output NC data.
A.4.5
Referencing an
Optional Function
Table

Leave a Reply

Your email address will not be published. Required fields are marked *