Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
898
The meanings of the highorders bits of the specified word for referencing
the optional function table are as follows.
00: LEADER PART
01: TRAILER PART
02: PROCESS START
03: PROCESS END
04: FROM
05: LINEAR INTERPOLATION
06: CIRCULAR INTERPOLATION
07: THREAD CUTTING
08: THREAD CUTTING CYCLE
09: SPINDLE
0A: TURRET
0B: DWELL
0C: CSS CONTROL (spindle control)
0D: SUB PROGRAM (start and end of a subprogram)
0E: SPECIAL PROC. START
0F: SPECIAL PROC. END
10: BAR FEED MOTION
11: CAXIS PROCESS START
12: CAXIS PROCESS END
13: CAXIS PROCESS FROM
14: CAXIS PROCESS FIXED CYCLE
15: SPINDLE OPERATION
16: FIXED CYCLE FOR LATHE
17: OPTIONAL BLOCK OUTPUT Newly added
(3)Setting example
Example 1) G65P1000L1;
M1;
Assume that the above NC data for a miscellaneous machining call and
optional stop is output to the next block after block number 0.
Specify the following for the MTF function table:
MTF 2000= 0300, 0104, 0004, 0603, 0004, 000E, 1700, 0000, 0000, 0000
FEED % ; 0 : MTF2300
MTF 2300= 472F, 0041, 504F, 03E8, 4C1F, 0001, 0004, 0605, 0004, 0000
G 65 P 1000 L 1 ; M1 ;
The following special NC data be output:
%××××;
O
G65P1000L1;
M1;

Leave a Reply

Your email address will not be published. Required fields are marked *