Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
900
Message Meaning Remedy
CAN NOT USE THIS
FUNCTION
A certain function can not be used because
of incorrect using condition.
DATA IS NOT CORRECT An error is included in any one of input data. The data indicated by the cursor includes an
error. Input correct data.
KEY IN AGAIN Input data is wrong. Input correct data for each question.
KEY IN DATA Necessary data is not entered. Input correct data for each question.
LACK OF NECESSARY DATA Necessary data is not set. Set necessary data.
SYSTEM PROGRAM ERROR Program fails due to any reason. Re–examine the program.
THIS IS A NULL AND VOID
KEY NOW.
Invalid soft key is pressed.
(Example) ELEMENT DELETE soft key is
pressed to delete the start point element
during setting of multiple face milling figure.
(The start point element can not be deleted
according to the specification.)
WARNING! CHECK INPUT
DATA
1) Incremental command is continued for
over 50 elements at defining a part figure.
2) Program fails due to any reason.
1) Specify an absolute value halfway not to
continue an incremental value for over 50
elements.
2) Re–examine the program.
A.5
ERROR MESSAGES
A.5.1
Errors Common to All
Screens

Leave a Reply

Your email address will not be published. Required fields are marked *