Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
901
Message Meaning Remedy
END POINT OR GROOVE
DIRECTION IS NOT
CORRECT!
At the entry of equal pitch continuous groove,
an error exists at the end point or in the
groove direction and the figure can be
correctly defined.
Check the end point or the groove direction.
END POINT OR NECK
WIDTH IS NOT CORRECT!
At the entry of neck corner, an error exists
and in the end point value specification or the
neck width and the figure can not be correctly
defined.
Check the end point value or neck width.
END POINT, PITCH OR
QUANTITY IS NOT
CORRECT!
At the entry of equal pitch continuous groove,
any one of the end point, pitch or quantity is
incorrect.
Check the end point, pitch or quantity
GROOVE WIDTH OR PITCH
IS NOT CORRECT!
At the entry of equal pitch continuous groove,
the pitch value is smaller than the groove
width.
Increase the pitch value to larger than the
groove width.
KEY IN REPEAT NO. Figure elements are tried to copy without
entering the repetition number.
Input the repetition number.
LAST ELEMENT IS NOT
ARROW!
At the entry of equal pitch continuous groove,
the last element is not the arrowed element.
LAST END POINT IS
UNDEFINED!
Pattern figure is tried to enter before the end
point value of the last element is defined.
Set the end point of the last element.
THE LAST FIGURE
ELEMENT HAS NO END
POINT.
At setting multiple face milling figures, the
end point value of the last figure is not
defined.
Define the end point value of the last figure,
then input the next figure data.
TOO MANY ELEMENT
SYMBOL
1) At the entry of part figure, the number of
external elements exceeds the limited
number.
2) At the entry of part figure, the number of
internal elements exceeds the limited
number.
Decrese the number of elements.
A.5.2
Errors at Defining
Figures (Menu 2)

Leave a Reply

Your email address will not be published. Required fields are marked *