Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
904
Message Meaning Remedy
COLLATING ERROR
(M: MEMORY I: INPUT)
The data read from an external unit is
collated with the data on the main memory,
but not matched.
ILLEGAL FORMAT DATA
DETECTED
The data input from an external unit is
different from the specified format.
I/O NOT READY Input/output unit is not prepared. The
following reasons are considerable.
1) The unit is not powered.
2) Baud rate is incorrect.
3) In the case of reading from a cassette
tape, a reading file is not recorded on the
tape.
LOCKED PARAMETER Data is tried to enter a locked parameter.
NOT FOUND ID. NO. When the tool information contents are
copied, the tool ID No. specified as a copy
source is not found.
Check the tool ID No.
THIS TOOL HAS ALREADY
REGISTERED
At tooling one by one on the tooling data
screen, the tool ID No. already tooled is
specified.
TV ERROR INCLUDING TV error is included in the read tape.
A.5.6
Others

Leave a Reply

Your email address will not be published. Required fields are marked *