Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
905
B
RESTRICTIONS ON EACH SYSTEM
The following tables list the functions and parameters not supported by
the models/series.
Model Series
FANUC Series 16TA CAP II
FANUC Series 16TTA CAP II
5700
(1)Unsupported functions
Heading Unsupported function
III 3.2.2 Part figure input (Input method with
figure)
Trapezoidal groove definition
III 3.2.6 Batch input functions for chamfering
and corner R
Corner R batch input
III 3.2.7 Pattern figure input function Corner necking (*1)
III 3.2.8 Function for defining the center of an
arc according to a given single
coordinate
All functions
III 3.4 Machining Definition All functions (*2)
III 5.1 Balance Cutting Process Tool specification method (*3)
IV 2.5 File Data Input/Output Function All functions
VII 1.13 Outputting NC data in the FS 15/16
Format
All functions
VIII 1.4 Milling in Multiple Planes All functions
VIII 1.5 C–Axis Machining with a Machining
Plane Specified
All functions
VIII 2. MACHINING DEFINITION (MENU 4) All functions (*2)
X AUTOMATIC PROCESS
DETERMINATION FUNCTION
All functions (*4)
*1 The automatic thread depth specification function for corner type 3 cut
by necking (necking for threads) is not supported.
*2 Menu 4 (machining definition) has a different definition screen layout.
See Appendix B.1 for details.
*3 Balance cutting uses different tool specification methods. See
Appendix B.1 for details.
*4 Details of the automatic process determination function vary. See
Appendix B.2 for details.

Leave a Reply

Your email address will not be published. Required fields are marked *