Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
906
(2)Setting data
The setting data has been changed because the automatic process
determination function has been improved. See Appendix B.2 for
details.
(3)System parameters
It is impossible to use the parameters that cannot be specified under
Data setting and the parameters listed below, although they are
described in the manual.
Parameter No. Data type Description
0671 Integer Machining area (CAF) drawing color
0703 0, 1
designation (8 bits)
Bit 7 For the automatic process determination function, use of a drill bit with the
same diameter as the bore is
0 : Disabled
1 : Enabled
0704 0, 1
designation (8 bits)
Bit 6 On the machining definition screen, a blank figure (BWP) is
0 : Not filled in
1 : Filled in
Bit 7 On the machining definition screen, a machining area (CAF) is
0 : Not filled in
1 : Filled in
0705 0, 1
designation (8 bits)
Bit 6 When another module requests the right to use graphics exclusively
during simulated machining, the right is
0 : Not relinquished
1 : Relinquished
0708 0, 1
designation (8 bits)
Bit 4 The material and tooling information input/output format is
0 : Binary
1 : ISO/EIA
(4)It is impossible to use the MTFs that cannot be specified under “Data
setting,” the MTFs described in VII 1.13, and the MTFs listed below,
although they are described in the manual.
Parameter numbers 2000 to 2999
Parameter No. Description
2209 Beginning of cylindrical interpolation
2210 End of cylindrical interpolation
2214 Polar coordinate interpolation start block
2215 Polar coordinate interpolation cancel block
Function code
Function
code
Function Remark
6 4 0 2 G7.1 is output. G code for cylindrical interpolation is output.

Leave a Reply

Your email address will not be published. Required fields are marked *