Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
908
soft key “4” in the menu screen.
Fig. B.1.1.1 (a)
The major types of machining required for machining are displayed on the
soft keys below the screen as shown above.
Press CENTER HOLE: the soft key display changes to the menu for
center hole drilling. (See Fig. B.1.1.1 (b)).
Press ”TURN”: the soft key display changes to the menu for turning. See
Fig. B.1.1.1 (c).
Press GROOV THREAD: the soft key display changes to the menu for
grooving and thread cutting. See Fig. B.1.1.1 (d).
Press “C–AXIS”: the soft key display changes to the menu for C–axis
machining. See Fig. B.1.1.1 (e).
Press key
at the leftmost end under the conditions shown in Fig.
B.1.1.1 (b) to (e) above, and the soft key display shown in Fig. B.1.1.1
(a) above is selected.
Press key
at the rightmost end: the soft key display changes in the
following sequence:
(b)(c)(d)(e)(b) ....
Fig. B.1.1.1 (b)
[CENTER DRILL] Press this key for center drilling. . .
[DRILLING] Press this key for drilling. . . . . . . .
[REAMER] Select to perform reaming. . . . . . . . .
[TAP] Select to perform tapping. . . . . . . . . . . . . .
[SUB CYCLE] Press this key for sub cycle. . . . . . .
B.1.1.1
Selection of kinds of
machining

Leave a Reply

Your email address will not be published. Required fields are marked *