Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
73
4) Neck diameter (PH point DX value) and width, side depth, depth,
corner R (DIN Standards)
Diameter (X axis) Depth
(DT)
Corner R
(R)
Width
(WT)
Side depth
(W1)
Under 18 mm
Under 0.7087 inch
.25 mm
.0098 inch
.6 mm
.0236 inch
2.0 mm
.0787 inch
.1 mm
.0039 inch
Above 18 mm below 80 mm
0.7087 to 3.15 inch
.35 mm
.0138 inch
.6 mm
.0236 inch
2.5 mm
.0984 inch
.2 mm
.0079 inch
Above 80 mm
Above 3.15 inch
.45 mm
.0177 inch
1.0 mm
.0394 inch
4.0 mm
.1575 inch
.3 mm
.0118 inch
Example
Method of definition when defining the figure of this illustration.
a) Defining the figure by the existing method without using the
pattern figure input method
(1)Definition from zero point direction °²¼R²R°². . .
(2)Definition from chuck direction ³±R³R½³±. . . . . . .
In this way, each element is defined one at a time.
b) Defining the figure using pattern figure input
(1)Definition from zero point direction ° (End point PH). . .
(2)Definition from check direction ³ (End point PV). . . . . . .
Inputting elements in this way, after keying in the end point value (PH or
PV), press neck corner”.
Input the following data with regard to each question for (1).
NECK TYPE P = 1. . . . . . . .
Questions and illustrations explaining neck type 1 are displayed here and
therefore the following data should be input.
Define direction DD =1 (0: PV³ PH, 1: PH ³ PV). . . . . . . .
End point PV EDX = 60.. . . . . . . . . .
EZ = 20.
Width WT = 2.5 (Automatic setting). . . . . . . . . . . . . . . .
Depth DT = 0.35 (Automatic setting). . . . . . . . . . . . . . . . .
Corner R R = 0.6 (Automatic setting). . . . . . . . . . . . . .
Surface roughness SR = 2 (Automatic setting). . . . . . .

Leave a Reply

Your email address will not be published. Required fields are marked *