Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
910
Fig. B.1.1.2 (a)
When Menu No.4 is selected again after completion of machining
definition, the screen shown above will appear.
[NEW] Press this key when reinstructing the process. . . . . . . . . .
from the start after all processes are cancelled.
[CORRECTION] Press this key to modify or change part of the. .
process.
When “CORRECTION” is depressed, following screen appears.
Fig. B.1.1.2 (b)
Each time “Cursor ± or “Cursor ° is depressed when the above screen
appears, the position of the cursor of the process No. on the process table
moves up and down.
Press “Cursor ± or “Cursor ° to select an arbitrary Process No., and
correct the machining contents.
Also in this screen, the process can be inserted, deleted and replaced.
(Sample Insertion)
PROC 01: DRILLING
PROC 02: ROUGHING OF OUTER FIGURE
PROC 03: FINISHING OF OUTER FIGURE
PROC 04:
B.1.1.2
Process change and
correction

Leave a Reply

Your email address will not be published. Required fields are marked *