Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
911
(1)Press “Cursor ± or “Cursor ° to select the Process No. to be inserted.
(For example, select process 03).
(2)Select the machining contents to be inserted (for example, press
“TURN” and press ROUGH I.D.”).
The results are as follows.
PROC 01: DRILLING
PROC 02: ROUGHING OF OUTER FIGURE
PROC 03: ROUGHING OF INNER FIGURE (INSERTION)
PROC 04: FINISHING OF OUTER FIGURE
PROC 05:
(Sample Deletion)
(1)Press “CURSOR ± or “CURSOR ° to select the process No. to be
deleted.
(2)Press PROC DELETE”.
(Replacement)
(1)Insert a new machining process, then delete the old one, or
(2)Delete the old one, then insert a new machining process.
Only one process can be corrected if required after all processes are
prepared, and only NC data of its process can be output.
Press “CORR. & OUT when the screen in Fig. B.1.1.2 (a) appears: the
screen as shown in Fig. B.1.1.2 (b) will appear.
Select the process to be output independently as NC data, using “Cursor
*” or Cursor *, and press NEXT PAGE”.
If the working process is specified on the process chart screen, the screen
changes and the tool information required for working definition is
prompted.
Tool data is displayed on the lefthand side of the screen and the tool
picture is displayed on the righthand side of it. (The tool picture is
displayed if the optional animationdrawing function is available. To
display the tool picture, press the soft key “CHECK”.)
B.1.1.3
Output of only single
process
B.1.1.4
Tool data

Leave a Reply

Your email address will not be published. Required fields are marked *