Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
912
The following prompts are displayed.
Turret No. TL = (NOTE 1). . . . . . . . . . . . . . . .
Tool selection number TN = (NOTE 2) . . . . . .
Tool offset number TM = . . . . . . . . .
Tool management number ID = (NOTE 3). . .
NOTE
1 The turret No. prompt is displayed if there are more than 1
tool resets. The number of tool rests is to be set in No.MTF
1050.
2 Input an integer consisting of up to two digits as TN and TM.
3 The tool management number (ID) to be input must have
been registered in the tool data (see VI2.1). If a tool
management number (ID) not registered in the tool data is
input, a message No tool management number is found.
is displayed. if “DEL”, “INPUT” is keyed in, the registered
tool management number is deleted from the tooling
information.
When using a tool already registered in the tooling information, the other
data is automatically displayed if the tool selection number (TN) is input.
At new registration, the tool configuration data and setting data registered
in the tool data are displayed if the tool management number (ID) is input.
(1)Turning Tools
Tool Configuration Data Display (Display Only; Not Alterable)
(Center drill)
Tool type TP; center drill
Tool tip angle AN;
Drill diameter DD;
(Drill)
Tool type TP; drill
Tool tip angle AN;
Drill diameter DD;
(Reamer)
Tool type TP; reamer
Tool diameter DT;
Cutter length LT;
Biting length LE;
(Tap)
Tool type TP; tap
Tool diameter DT;
Cutter length LT;
Biting length LE;
Pitch PT;

Leave a Reply

Your email address will not be published. Required fields are marked *