Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
913
(Groove/Neck/Cut off)
Tool type TP; grooving/necking
Tool tip radius RN;
Cutter angle AC;
Tool tip angle AN;
Tool tip width WN;
Virtual tool tip position XN;
ZN;
(Thread)
Tool type TP; thread
Cutter angle AC;
Tool tip angle AN;
Virtual tool tip position XN;
ZN;
(General)
Tool type TP; general
Tool tip radius RN;
Cutter angle AC;
Tool tip angle AN;
Cutter protective angle AP;
Virtual tool tip position XN;
ZN;
(Finger)
Tool type TP; finger
Virtual tool tip position XN;
Setting Data Prompts (Settable/Alterable)
Setting angle AS = (NOTE 1) . . . . . . . . . . . . . .
Setting position XS = . . . . . . . . . . . .
ZS =
Spindle rotating direction SD = (0 = CW, 1 = CCW) (NOTE 2). . . .
Holder number HL = (NOTE 3). . . . . . . . . . . .
NOTE
1 The setting angle (AS) follows the system parameter
No.200 drawing format. Not displayed if the center drill, drill,
finger tool.
2 The spindle rotating direction prompt is displayed when
system parameter No.702 bit 1 = 1.
3 The holder number (HL) prompt is displayed if the optional
animation–drawing function is available. Set the
animation–drawing tool holder number.

Leave a Reply

Your email address will not be published. Required fields are marked *