Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
914
(2)C–Axis Tools
Tool Configuration Data Display (Display Only; Not Alterable)
(Center drill)
Tool type TP; Caxis center drill
Tool material MT;
Tool diameter DT;
Cutting diameter DS;
Cutter length LT;
Tool tip angle AT;
(Drill)
Tool type TP; Caxis drill
Tool material MT;
Tool diameter DT;
Cutter length LT;
Tool tip angle AT;
(Tap)
Tool type TP; Caxis tap
Tool material MT;
Tool diameter DT;
Cutter length LT;
Biting length LE;
Pitch PT;
(End mill)
Tool type TP; Caxis end mill
Tool material MT;
Tool diameter DT;
Cutting diameter DS;
Cutter length LT;
Number of tools NT;
Setting Data Prompts (Settable/Alterable)
Setting direction CP = (0: side working; 1: end working). . . . . .
Setting position XS = . . . . . . .
ZS =
Rotation direction TR = (0: clockwise; 1: counterclockwise) . . . . .
Holder number HL = (NOTE). . . . . . .
NOTE
The holder number (HL) prompt is displayed if the optional
animation–drawing function is available.
When creating an NC data, interference is checked or offset is calculated
according to the tool configuration. Note that a correct NC data is not
output unless tool data is input accurately.
If tooling information has already been created, the other data is
automatically displayed when the tool management number (TN) is
input. If there are no changes, press NEXT PAGE to proceed to the next
screen.

Leave a Reply

Your email address will not be published. Required fields are marked *