Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
915
To add or change data, move the cursor with CURSOR X”, “CURSOR
Y” and input the data.
For tool configuration data, just the tool data of the set tool management
number (ID) is displayed, so it is impossible to change data directly.
When proceeding to the next screen by pressing NEXT PAGE, the set
data is registered as tooling information. Also if a tool management
number having a tool type not compatible with the current process has
been input, a message This tool does not fit the current process. is
displayed.
Meaning of Soft Keys
“ESCAPE” Return to the menu screen.. . . . . . . . . .
PAGE BACK Return to the last screen (working process. . . . . . .
list screen).
“CHECK” Displayed if the optional animation. . . . . . . . . . .
drawing function is available. The tool
picture is displayed according to the
currently displayed data. If this key is
pressed after changing tooling information,
the tool picture is displayed anew according
to the changed data.
TOOL DATA A tool data list is displayed.. . . . . . .
TOLING INFOR. A tooling information list is displayed.. . .
NEXT ID Displayed if the optional automatic process. . . . . . . . . .
decision function is available. Select the
tool of the next ID number in which the
working process type (KP) is set.
NEXT PAGE Proceed to the next page.. . . . . . .
In the 2tool rest type, the tool configuration picture is inverted if the
turret number is changed. Also the following screen is displayed in the
balance cut process.
In the diagram, the upper picture is the tool for cutter No.1 and the lower
picture is the tool for cutter No.2.
(Cautions about Tool Picture)
1. The chip only is displayed if the holder has not been defined for the
tool.
2. It is impossible to change the chip or holder scale value.

Leave a Reply

Your email address will not be published. Required fields are marked *