Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
917
Fig. B.1.1.6 (b) Designation of passing point
Set the number of simultaneous moving axes in a motion from the
machining start position to (XA1, ZA1) and the number of simultaneous
moving axes in a motion from (XE2, ZE2) to the next machining start
position using system parameter Nos.107 to 115 bits 3, 4.
NOTE
The conversation screen of the established passing point
can be skipped by each type of machining. (By setting
system parameter No.107 to 115)

Leave a Reply

Your email address will not be published. Required fields are marked *