Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEM
918
When the OD cutting or ID machining process is specified, you are
requested to enter the cutting direction.
Specify the direction to the question regarding the cutting direction “CD
=”.
At this time, it can be entered not only from the ten key pad but also from
the Software key.
Cutting direction CD =. . . . . . . . . . . . . . . .
± Negative direction of X axis
° Positive direction of X axis
² Negative direction of Z axis
³ Positive direction of Z axis
When the X axis negative direction is selected in OD cutting, the cutting
conditions for facing are automatically set. Also, the facing part is
automatically selected for the machining area. When the direction other
than the X axis negative direction is selected, cutting conditions for OD
machining are set.
In the case of ID machining, cutting conditions for ID cutting are set
whatever direction nay be selected.
B.1.1.7
Cutting direction

Leave a Reply

Your email address will not be published. Required fields are marked *