Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
B. RESTRICTIONS ON EACH SYSTEMAPPENDIX
919
The cutting conditions are automatically set and displayed according to
the kinds of selected materials. Change only the desired items, while
monitoring the CRT screen. If you want to change the feedrate to 75%
of the displayed value, for example, multiply the displayed value by 0.75
as follows.
(Examples) F1 =
3
*
0
.
7
5
INPUT
The cutting conditions and meanings of the system questions are
described below according to machining data.
(1)Center drilling conditions
CLEARANCE C = Clearance quantity (mm) . . . . . . .
DEPTH OF CUT D = Depth of cut (mm). . . . .
SPINDLE SPEED N = Spindle speed (rpm) . . . . .
FEED RATE F = Feedrate (mm/rev). . . . . . . . .
(2)Drilling conditions
Cutting conditions for drilling comprise type 1, 2 and 3 according to
the movement of a drill.
CUTTING CONDITIONS 1
CLEARANCE C = Clearance (mm or inch). . . . . . . . .
CUT POINT Z = Position of cut end point . . . . . . . . . . .
(mm or inch)
(When bit 7 of system parameter
702 is 1)
or
DEPTH OF CUT D = Depth of cut (mm or inch). . . . . . .
(When bit 7 of system parameter
702 is 0)
SPINDLE ROTATION N = Spindle rotation speed (rpm). . .
FEED RATE F1 = Feed rate (mm/rev or inch/rev). . . . . . . . . . .
B.1.1.8
Cutting conditions

Leave a Reply

Your email address will not be published. Required fields are marked *