Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
74
When “EXEC” is pressed the figure based on the data set is drawn.
Input the following data with regard to each question for 2.
NECK TYPE P = 1. . . . . . . . . .
Questions and illustrations explaining neck type 1 are displayed here and
therefore the following data should be input.
Define direction DD =0 (0: PV³ PH, 1: PH ³ PV). . . . . . . .
End point PH EDX = 40.. . . . . . . . . .
EZ = 0.
Width WT = 2.5 (Automatic setting). . . . . . . . . . . . . . . .
Depth DT = 0.35 (Automatic setting). . . . . . . . . . . . . . . . .
Corner R R = 0.6 (Automatic setting). . . . . . . . . . . . . .
Surface roughness SR = 2 (Automatic setting). . . . . . .
When “EXEC” is pressed the figure based on the data set is drawn.
i) The figure defined at neck corner input is separated and defined
into direction arrow elements and R.
ii) Carry out corrections and deletions one element at a time.
NOTE
1 Definition is possible if the element directly in front of corner
R is an element other than G/N/T, but the end point value
directly in front must be decided. Furthermore, it is not
possible to create it as the first element.
2 The neck is created in the corner of the vertical and
horizontal plane.
It is possible in the taper plane.
3 If define direction DD = 0 is input, the next end point symbol
is displayed as PH. Conversely, if define direction DD = 1
is input, the next end point symbol is displayed as PV.
Furthermore, the neck direction is decided automatically by
the define direction and end point value.
Examples: Illustrations type 2 for horizontal figures
a) When define direction is 0 (PV: vertical plane ³ PH: horizontal plane)
End point PH is upper left with regard to PV End point PH is upper right with regard to PV
End point PH is lower left with regard to PV End point PH is lower right with regard to PV

Leave a Reply

Your email address will not be published. Required fields are marked *